So I've modeled my own scaffolding as skeinforge doesn't seem to do it effectively. You can see it in the attached picture (upside down). My question is how thin should I make the walls so that skeinforge doesn't try to fill them in but treat each wall as just a single pass on each layer? https://reprap.org/forum/read.php?154,364212,364212#msg-364212 Sat, 05 Sep 2026 07:58:17 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?154,364212,372762#msg-372762 https://reprap.org/forum/read.php?154,364212,372762#msg-372762 can you post the specs so that i dont have to experiment on settings and size.
:)]]> palawanisland Skeinforge Sat, 21 Jun 2014 08:50:07 -0400 https://reprap.org/forum/read.php?154,364212,364312#msg-364312 https://reprap.org/forum/read.php?154,364212,364312#msg-364312 If using SFACT: Edge width
If it is not extruded make it 25%wider..]]> ahmetcemturan Skeinforge Tue, 03 Jun 2014 01:53:27 -0400 https://reprap.org/forum/read.php?154,364212,364212#msg-364212 https://reprap.org/forum/read.php?154,364212,364212#msg-364212
My question is how thin should I make the walls so that skeinforge doesn't try to fill them in but treat each wall as just a single pass on each layer?]]> fizgig10 Skeinforge Mon, 02 Jun 2014 17:57:15 -0400