Hey, My Rostock is now ready. Everything Done. Now it goes to the calibration Autoleveling with servo probe is mounted and working. Hardware see signature Software: repetier host / repetier firmware 0.92 / Current Config at attach My Rostock always goes beyond the heater bed edge. I am now trying for hours with all possible values, have everything measured several times and entered into the firmware. Unfortunately, without success. Here's a video of the problem: [www.youtube.com] G28 G32 S0 manually push of switch with my hand Manual emergency shut down in pronterface I Any ideas? I'm really desperate -.- regards https://reprap.org/forum/read.php?178,479634,479634#msg-479634 Fri, 07 Aug 2026 23:43:28 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?178,479634,480002#msg-480002 https://reprap.org/forum/read.php?178,479634,480002#msg-480002 zelos11 Delta Machines Fri, 06 Mar 2015 08:17:48 -0500 https://reprap.org/forum/read.php?178,479634,479769#msg-479769 https://reprap.org/forum/read.php?178,479634,479769#msg-479769 vreihen Delta Machines Thu, 05 Mar 2015 20:40:02 -0500 https://reprap.org/forum/read.php?178,479634,479634#msg-479634 https://reprap.org/forum/read.php?178,479634,479634#msg-479634
My Rostock is now ready. Everything Done. Now it goes to the calibration Autoleveling with servo probe is mounted and working.
Hardware see signature
Software: repetier host / repetier firmware 0.92 / Current Config at attach

My Rostock always goes beyond the heater bed edge. I am now trying for hours with all possible values, have everything measured several times and entered into the firmware. Unfortunately, without success.

Here's a video of the problem:
[www.youtube.com]
G28
G32 S0
manually push of switch with my hand
Manual emergency shut down in pronterface

I Any ideas? I'm really desperate -.-

regards]]> zelos11 Delta Machines Thu, 05 Mar 2015 15:49:33 -0500