Hi, im gearing up to get a dual nozzle setup on my delta. I have two different hotends that might not have the same height and washers under the mounting plates might not be the most sensible tuning mechanism. While looking for effector design I didnt find any that had an adjustment mechanism for that, so im wondering how this is supposed to be done? Cheers https://reprap.org/forum/read.php?178,603195,603195#msg-603195 Mon, 08 Jun 2026 07:03:49 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?178,603195,603552#msg-603552 https://reprap.org/forum/read.php?178,603195,603552#msg-603552
Its probably a bit finicky but if I glue nuts on the top of the effector then I can make a screw advanced space similar to the endstop adjusters.]]> sungod3k Delta Machines Sat, 02 Jan 2016 09:55:23 -0500 https://reprap.org/forum/read.php?178,603195,603537#msg-603537 https://reprap.org/forum/read.php?178,603195,603537#msg-603537 nebbian Delta Machines Sat, 02 Jan 2016 09:25:42 -0500 https://reprap.org/forum/read.php?178,603195,603195#msg-603195 https://reprap.org/forum/read.php?178,603195,603195#msg-603195
im gearing up to get a dual nozzle setup on my delta. I have two different hotends that might not have the same height and washers under the mounting plates might not be the most sensible tuning mechanism.

While looking for effector design I didnt find any that had an adjustment mechanism for that, so im wondering how this is supposed to be done?

Cheers]]> sungod3k Delta Machines Fri, 01 Jan 2016 11:40:23 -0500