Ok, I have been trying to fine tune my esteps as the extruder pulls in just under the required ammount. I trued the command M92 Exxx as per the wiki and this did not seem to change anything. I have also tried editing the value in the firmware, though this was set to 875 but the wiki said the default is 980 any ideas? https://reprap.org/forum/read.php?214,183541,183541#msg-183541 Mon, 12 Oct 2026 15:21:03 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?214,183541,183570#msg-183570 https://reprap.org/forum/read.php?214,183541,183570#msg-183570 smartdev Huxley Sun, 10 Feb 2013 07:48:22 -0500 https://reprap.org/forum/read.php?214,183541,183541#msg-183541 https://reprap.org/forum/read.php?214,183541,183541#msg-183541 smartdev Huxley Sun, 10 Feb 2013 05:57:18 -0500