I have the RepRapDiscount RAMPS board and I am wondering about the four servo outputs. Has anybody used these for anything? https://reprap.org/forum/read.php?219,251798,251798#msg-251798 Fri, 07 Aug 2026 12:31:07 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?219,251798,253757#msg-253757 https://reprap.org/forum/read.php?219,251798,253757#msg-253757
BTW, that looks like a nice little control board. Thanks for posting that. Bookmarked!]]> BrentB RAMPS Electronics Thu, 10 Oct 2013 23:11:18 -0400 https://reprap.org/forum/read.php?219,251798,253581#msg-253581 https://reprap.org/forum/read.php?219,251798,253581#msg-253581
I got THIS board from ebay to run my extra fans and things. It's pretty handy as I could not find any 5V computer case fans.]]> uMinded RAMPS Electronics Thu, 10 Oct 2013 10:53:01 -0400 https://reprap.org/forum/read.php?219,251798,253397#msg-253397 https://reprap.org/forum/read.php?219,251798,253397#msg-253397
BTW, the video was linked to from here, the Marlin source repo: [github.com]
The README displayed there has a lot of info about setting up auto-levelling in marlin.]]> BrentB RAMPS Electronics Wed, 09 Oct 2013 23:04:32 -0400 https://reprap.org/forum/read.php?219,251798,253388#msg-253388 https://reprap.org/forum/read.php?219,251798,253388#msg-253388
I was using my servo pins to control all of the cooling fans and an overhead light.]]> uMinded RAMPS Electronics Wed, 09 Oct 2013 22:31:44 -0400 https://reprap.org/forum/read.php?219,251798,253190#msg-253190 https://reprap.org/forum/read.php?219,251798,253190#msg-253190
Last night I happened to see this video of automatic printer bed leveling. A servo is mounted to the x carriage, and swings down a probe to detect bed height at three locations. The firmware then follows that gradient when printing. Bed Auto-leveling]]> BrentB RAMPS Electronics Wed, 09 Oct 2013 09:41:58 -0400 https://reprap.org/forum/read.php?219,251798,253067#msg-253067 https://reprap.org/forum/read.php?219,251798,253067#msg-253067
Here is the board pinouts:
Overview
Schematic]]> uMinded RAMPS Electronics Tue, 08 Oct 2013 23:52:49 -0400 https://reprap.org/forum/read.php?219,251798,251798#msg-251798 https://reprap.org/forum/read.php?219,251798,251798#msg-251798
Has anybody used these for anything?]]> BrentB RAMPS Electronics Fri, 04 Oct 2013 21:39:34 -0400