While I'm waiting on a few misc parts, I wanted to test the full range of movement on all axis to make sure there isn't anything binding. I had originally upladed the marlin firmware, but any frontends complain about not having a temp reading (which is legit). I then tried one of the "test" code samples, which seem to just rotate the motors each direction in a loop. This worked, although I found that the belted units weren't very smooth. What I'd like to do is be able to watch the full range of motion, and ideally control it. Any ideas? https://reprap.org/forum/read.php?219,325769,325769#msg-325769 Mon, 16 Mar 2026 23:55:37 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?219,325769,325878#msg-325878 https://reprap.org/forum/read.php?219,325769,325878#msg-325878 cat.farmer RAMPS Electronics Sun, 16 Mar 2014 19:41:07 -0400 https://reprap.org/forum/read.php?219,325769,325769#msg-325769 https://reprap.org/forum/read.php?219,325769,325769#msg-325769
Any ideas?]]> ncshooter426 RAMPS Electronics Sun, 16 Mar 2014 14:46:30 -0400