This may sound stupid, but I have been trying to autotune my printer, but whenever I put in the numbers my software tells me to (Repetier host), into my firmware(Marlin firmware). It doesn't seem to have any effect whatsoever. My nozzle still does a sinusoidal temperature range of + or - 5 degrees from my desired temperature. I've attached a screenshot showing where I have been inputting my numbers, I may be putting something in wrong. Any advice would be greatly appreciated! Thanks a bunch sincerely, Max https://reprap.org/forum/read.php?219,371616,371616#msg-371616 Mon, 10 Aug 2026 10:17:22 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?219,371616,372626#msg-372626 https://reprap.org/forum/read.php?219,371616,372626#msg-372626
PID tuning from Wiki
[reprap.org]]]> vegasloki RAMPS Electronics Fri, 20 Jun 2014 19:32:25 -0400 https://reprap.org/forum/read.php?219,371616,371616#msg-371616 https://reprap.org/forum/read.php?219,371616,371616#msg-371616
sincerely,
Max]]> MaxThom RAMPS Electronics Wed, 18 Jun 2014 13:07:43 -0400