Good day all Bought a He3d delta printer and got a assembly guide with it, but the wiring seems to be misleading. Im not used to the colour orientation of the stepper motors with the wiring diagram I got with the printer. As per attached he3d wiring, seen from the opposite side from 12v power in – red/blue/black/green for the xyz axis and red/blue/green/black for the extruder motor (the black and green are swapped for the extruder). As per attached picture from internet, seen from the opposite side from 12v power in (Also the same for my Prusa) - black/green/blue/red for the xyz axis and the extruder. A bit confused here? https://reprap.org/forum/read.php?219,493982,493982#msg-493982 Sat, 11 Jul 2026 16:50:58 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?219,493982,494587#msg-494587 https://reprap.org/forum/read.php?219,493982,494587#msg-494587 Bking1340 RAMPS Electronics Wed, 08 Apr 2015 21:47:05 -0400 https://reprap.org/forum/read.php?219,493982,494205#msg-494205 https://reprap.org/forum/read.php?219,493982,494205#msg-494205 just hold any pair of wires together and try turning the motor
if it turns easy the two wires are from different coils
if its real hard to turn they are from the same coil


Don]]> Don Recardo RAMPS Electronics Wed, 08 Apr 2015 07:32:40 -0400 https://reprap.org/forum/read.php?219,493982,494038#msg-494038 https://reprap.org/forum/read.php?219,493982,494038#msg-494038 cdru RAMPS Electronics Tue, 07 Apr 2015 17:32:28 -0400 https://reprap.org/forum/read.php?219,493982,493993#msg-493993 https://reprap.org/forum/read.php?219,493982,493993#msg-493993 george4657 RAMPS Electronics Tue, 07 Apr 2015 15:54:37 -0400 https://reprap.org/forum/read.php?219,493982,493982#msg-493982 https://reprap.org/forum/read.php?219,493982,493982#msg-493982
Bought a He3d delta printer and got a assembly guide with it, but the wiring seems to be misleading. Im not used to the colour orientation of the stepper motors with the wiring diagram I got with the printer.
As per attached he3d wiring, seen from the opposite side from 12v power in – red/blue/black/green for the xyz axis and red/blue/green/black for the extruder motor (the black and green are swapped for the extruder).
As per attached picture from internet, seen from the opposite side from 12v power in (Also the same for my Prusa) - black/green/blue/red for the xyz axis and the extruder.

A bit confused here?]]> Bking1340 RAMPS Electronics Tue, 07 Apr 2015 15:24:15 -0400