Ramps moving issue delays Hi, im adding a ramps board to my 3d printer and all seems good, temps are fine, endstops, ect. It seems that when i use the soft to move an axis it stops after a few commands. For example, i use pronterface to move 10mm, it does once or twice then stops. I need to restart the printer and reconnect the soft to regain control, but it does it again soon after. Any ideas? For info 400 watt psu with 30+ amps Thanks https://reprap.org/forum/read.php?219,630787,630787#msg-630787 Thu, 16 Jul 2026 03:25:51 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?219,630787,630787#msg-630787 Ramps moving issue delays https://reprap.org/forum/read.php?219,630787,630787#msg-630787

For example, i use pronterface to move 10mm, it does once or twice then stops. I need to restart the printer and reconnect the soft to regain control, but it does it again soon after.

Any ideas?

For info 400 watt psu with 30+ amps


Thanks]]> TheT2 RAMPS Electronics Tue, 23 Feb 2016 15:46:51 -0500