start
echo: External Reset
Marlin1.0.0
echo: Last Updated: Apr 13 2015 16:25:29 | Author: (bq Witbox FW v1.4.2)
Compiled: Apr 13 2015
echo: Free Memory: 3357  PlannerBufferBytes: 1232
echo: Hardcoded Default Settings Loaded
echo: Steps per unit:
echo:  M92 X80.00 Y80.00 Z1600.00 E102.07
echo: Maximum feedrates (mm/s):
echo:  M203 X350.00 Y350.00 Z7.20 E80.00
echo: Maximum Acceleration (mm/s2):
echo:  M201 X1000 Y1000 Z10 E1000
echo: Acceleration: S=acceleration, T=retract acceleration
echo:  M204 S3000.00 T3000.00
echo: Advanced variables: S=Min feedrate (mm/s), T=Min travel feedrate (mm/s), B=minimum segment time (ms), X=maximum XY jerk (mm/s),  Z=maximum Z jerk (mm/s),  E=maximum E jerk (mm/s)
echo:  M205 S0.00 T0.00 B20000 X10.00 Z0.40 E5.00
echo: Home offset (mm):
echo:  M206 X0.00 Y0.00 Z0.00
echo: PID settings:
echo:   M301 P22.20 I1.08 D114.00
LCD initialized!
echo: SD card ok

Quote

// default settings

#define DEFAULT_AXIS_STEPS_PER_UNIT {80,80,600*8/3,102.073} // default steps per unit for Ultimaker
#define DEFAULT_MAX_FEEDRATE {350, 350, 7.2, 80} // (mm/sec)
#define DEFAULT_MAX_ACCELERATION {1000,1000,10,1000} // X, Y, Z, E maximum start speed for accelerated moves. E default values are good for Skeinforge 40+, for older versions raise them a lot.

#define DEFAULT_ACCELERATION 3000 // X, Y, Z and E max acceleration in mm/s^2 for printing moves
#define DEFAULT_RETRACT_ACCELERATION 3000 // X, Y, Z and E max acceleration in mm/s^2 for retracts

#define DEFAULT_ACCELERATION          3000    // X, Y, Z and E max acceleration in mm/s^2 for printing moves
#define DEFAULT_RETRACT_ACCELERATION  3000   // X, Y, Z and E max acceleration in mm/s^2 for retracts

#define FILAMENT_UNLOAD_RETRACTION_LENGTH 40

// #define FWRETRACT  //ONLY PARTIALLY TESTED
#ifdef FWRETRACT
  #define MIN_RETRACT 0.1                //minimum extruded mm to accept a automatic gcode retraction attempt
  #define RETRACT_LENGTH 3               //default retract length (positive mm)
  #define RETRACT_FEEDRATE 80*60         //default feedrate for retracting
  #define RETRACT_ZLIFT 0                //default retract Z-lift
  #define RETRACT_RECOVER_LENGTH 0       //default additional recover length (mm, added to retract length when recovering)
  #define RETRACT_RECOVER_FEEDRATE 8*60  //default feedrate for recovering from retraction
#endif