Prints leaning to side Well... I'm still calibrating my new MendelMax and aside from other minor problems, I have this leaning problem. All of my prints are leaning to one side. My setup: Arduino Mega 2560 with RAMPS1.3 Sprinter Skeinforge Repetier-Host all driving a MendelMax I have tried trimming the potentiometer on the Pololu drivers, following some tutorials (I tried this like thoudand times...), tightening all belts and screws (nothing wobbles even a little), moving the PC closer (I had quite a long cable leading to the Arduino from my PC), using another PC and I have even checked, that the motor doesn't have trouble pulling the fillament when moving from side to side. Now I'm completely lost and all my prints are completely useless as I want to use them mainly for construction, so I require at least some precision. Please help! I do also have trouble with oozing and stringing and the start of a thread getting not enough fillament, but that is only minor as I now focus on fixing this. Photo attached (hope you can see the problem there). https://reprap.org/forum/read.php?262,177086,177086#msg-177086 Wed, 22 Jul 2026 06:30:46 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?262,177086,177224#msg-177224 Re: Prints leaning to side https://reprap.org/forum/read.php?262,177086,177224#msg-177224 Check that your axes include a right angle!
Thanks for the reply, anyway.]]> Matouš Printing Thu, 17 Jan 2013 05:22:28 -0500 https://reprap.org/forum/read.php?262,177086,177095#msg-177095 Re: Prints leaning to side https://reprap.org/forum/read.php?262,177086,177095#msg-177095 konwiddak Printing Wed, 16 Jan 2013 11:18:07 -0500 https://reprap.org/forum/read.php?262,177086,177086#msg-177086 Prints leaning to side https://reprap.org/forum/read.php?262,177086,177086#msg-177086 All of my prints are leaning to one side.
My setup:
Arduino Mega 2560 with RAMPS1.3
Sprinter
Skeinforge
Repetier-Host
all driving a MendelMax

I have tried trimming the potentiometer on the Pololu drivers, following some tutorials (I tried this like thoudand times...), tightening all belts and screws (nothing wobbles even a little), moving the PC closer (I had quite a long cable leading to the Arduino from my PC), using another PC and I have even checked, that the motor doesn't have trouble pulling the fillament when moving from side to side.
Now I'm completely lost and all my prints are completely useless as I want to use them mainly for construction, so I require at least some precision.
Please help!
I do also have trouble with oozing and stringing and the start of a thread getting not enough fillament, but that is only minor as I now focus on fixing this.

Photo attached (hope you can see the problem there).]]> Matouš Printing Wed, 16 Jan 2013 09:27:17 -0500