Calibration print ok but it needs some help. Printed this out from Thingiverse for a little testing on the printer. Its a Makerfarm 8" i3 with a .4 Magma head printing ABS at .3 layer height. Im also using Slic3r and Pronterface to create and send the Gcode. Im ok with the box but the small stuff and the cylinders have some issues. It also looks like it blobs when it starts a new line of filament. Its great once it gets going but starting blobs a nice drop before it goes. My retract is at 1.2mm at the moment. I hope you all have some suggestions for me to try to get these little issues taken care of. https://reprap.org/forum/read.php?262,300612,300612#msg-300612 Thu, 08 Oct 2026 00:04:38 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?262,300612,301565#msg-301565 Re: Calibration print ok but it needs some help. https://reprap.org/forum/read.php?262,300612,301565#msg-301565 I did see a little ABS coming from the heater area so I cleaned it and tightened it back down, Do you think thats all it was? I havent had time to print another calibration print yet.]]> Floyd Printing Mon, 27 Jan 2014 00:03:16 -0500 https://reprap.org/forum/read.php?262,300612,301250#msg-301250 Re: Calibration print ok but it needs some help. https://reprap.org/forum/read.php?262,300612,301250#msg-301250 Ohmarinus Printing Sun, 26 Jan 2014 08:34:32 -0500 https://reprap.org/forum/read.php?262,300612,301112#msg-301112 Re: Calibration print ok but it needs some help. https://reprap.org/forum/read.php?262,300612,301112#msg-301112 Floyd Printing Sat, 25 Jan 2014 22:36:35 -0500 https://reprap.org/forum/read.php?262,300612,300909#msg-300909 Re: Calibration print ok but it needs some help. https://reprap.org/forum/read.php?262,300612,300909#msg-300909 gmh39 Printing Sat, 25 Jan 2014 13:58:28 -0500 https://reprap.org/forum/read.php?262,300612,300612#msg-300612 Calibration print ok but it needs some help. https://reprap.org/forum/read.php?262,300612,300612#msg-300612 Its a Makerfarm 8" i3 with a .4 Magma head printing ABS at .3 layer height. Im also using Slic3r and Pronterface to create and send the Gcode.

Im ok with the box but the small stuff and the cylinders have some issues. It also looks like it blobs when it starts a new line of filament. Its great once it gets going but starting blobs a nice drop before it goes. My retract is at 1.2mm at the moment.

I hope you all have some suggestions for me to try to get these little issues taken care of.]]> Floyd Printing Fri, 24 Jan 2014 21:35:40 -0500