So this is my 20 tooth GT2 belt pulley. The flange are 1.5mm thick. As you can see, the lower flange with support prints fine, however the upper flange fails to materialize. Any suggestions? I'm running at 195 degrees using 3mm filament. [bad photo #1] [bad photo #2] *** EDIT *** So, it took mere minutes for me to stop being lazy and read some past posts. Several parameters were suggested by others with similiar problems. I'll check a few settings before I continue this thread. https://reprap.org/forum/read.php?262,424550,424550#msg-424550 Thu, 21 May 2026 00:10:35 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?262,424550,424701#msg-424701 https://reprap.org/forum/read.php?262,424550,424701#msg-424701 Floyd Printing Sun, 26 Oct 2014 21:33:41 -0400 https://reprap.org/forum/read.php?262,424550,424614#msg-424614 https://reprap.org/forum/read.php?262,424550,424614#msg-424614 waitaki Printing Sun, 26 Oct 2014 16:57:07 -0400 https://reprap.org/forum/read.php?262,424550,424550#msg-424550 https://reprap.org/forum/read.php?262,424550,424550#msg-424550 The flange are 1.5mm thick.
As you can see, the lower flange with support prints fine, however the upper flange fails to materialize.
Any suggestions?
I'm running at 195 degrees using 3mm filament.

[bad photo #1]
[bad photo #2]

*** EDIT ***

So, it took mere minutes for me to stop being lazy and read some past posts.
Several parameters were suggested by others with similiar problems.

I'll check a few settings before I continue this thread.]]> Titanium69 Printing Sun, 26 Oct 2014 14:38:16 -0400