Bed autoleveling randomly does not work Hi folks, The quality of my prints have increased substantially since adding autoleveling. However, maybe one in five prints will have the following issue: [i.imgur.com] Notice the pattern on the brim. To be clear, when bed autoleveling works, the print comes out perfect. I have done the M48 test and I get 50 microns stdev, so looks like my servo is working correctly. I was thinking perhaps I have run into this issue? [github.com] Anyone else have a problem with bed autoleveling? https://reprap.org/forum/read.php?262,541449,541449#msg-541449 Fri, 07 Aug 2026 12:28:57 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?262,541449,546988#msg-546988 Re: Bed autoleveling randomly does not work https://reprap.org/forum/read.php?262,541449,546988#msg-546988
[3dprintboard.com]

There is a good modification you can make to accurately tell how level & flat the bed is. I plan on doing this tonight.

Alex]]> xelad Printing Tue, 18 Aug 2015 09:06:47 -0400 https://reprap.org/forum/read.php?262,541449,546952#msg-546952 Re: Bed autoleveling randomly does not work https://reprap.org/forum/read.php?262,541449,546952#msg-546952 dewasa Printing Tue, 18 Aug 2015 07:40:52 -0400 https://reprap.org/forum/read.php?262,541449,546503#msg-546503 Re: Bed autoleveling randomly does not work https://reprap.org/forum/read.php?262,541449,546503#msg-546503 xelad Printing Mon, 17 Aug 2015 04:34:11 -0400 https://reprap.org/forum/read.php?262,541449,542592#msg-542592 Re: Bed autoleveling randomly does not work https://reprap.org/forum/read.php?262,541449,542592#msg-542592 foul_owl Printing Wed, 05 Aug 2015 22:53:54 -0400 https://reprap.org/forum/read.php?262,541449,541449#msg-541449 Bed autoleveling randomly does not work https://reprap.org/forum/read.php?262,541449,541449#msg-541449
The quality of my prints have increased substantially since adding autoleveling. However, maybe one in five prints will have the following issue:
[i.imgur.com]

Notice the pattern on the brim.

To be clear, when bed autoleveling works, the print comes out perfect.

I have done the M48 test and I get 50 microns stdev, so looks like my servo is working correctly.

I was thinking perhaps I have run into this issue?
[github.com]

Anyone else have a problem with bed autoleveling?]]> foul_owl Printing Mon, 03 Aug 2015 15:41:06 -0400