It's been a long time since I had to ask a question here... I've tried other PLA and usually got it to stick to my Heated Kapton bed at the right temprature. However, I am having trouble finding the right temp for this MG Chemicals Red PLA. I have tried 60-95, 40, 0. Zero almost worked. It still lifted around the edges. Could it be I'm printing too hot? 210-220 (sugested) 50% White glue/water on the Kapton or just using blue tape work, but leave a mat finish. I would prefer the gloss of the glass or Kapton. I only tried once on raw glass. Will have to try again. Anyone using MG PLA please help. Thanks, Komb' https://reprap.org/forum/read.php?262,562309,562309#msg-562309 Thu, 10 Sep 2026 06:27:48 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?262,562309,563460#msg-563460 https://reprap.org/forum/read.php?262,562309,563460#msg-563460
Although the Box says 210-220c I tried running it at the usual PLA temp of 170-180c with a bed temp of 60c and it works fine.]]> Komb' Printing Sun, 27 Sep 2015 22:23:01 -0400 https://reprap.org/forum/read.php?262,562309,562309#msg-562309 https://reprap.org/forum/read.php?262,562309,562309#msg-562309
I've tried other PLA and usually got it to stick to my Heated Kapton bed at the right temprature.

However, I am having trouble finding the right temp for this MG Chemicals Red PLA.

I have tried 60-95, 40, 0. Zero almost worked. It still lifted around the edges.

Could it be I'm printing too hot? 210-220 (sugested)

50% White glue/water on the Kapton or just using blue tape work, but leave a mat finish. I would prefer the gloss of the glass or Kapton.

I only tried once on raw glass. Will have to try again.

Anyone using MG PLA please help.

Thanks,
Komb']]> Komb' Printing Thu, 24 Sep 2015 21:40:34 -0400