Hi. I have finished building my first printer. I am using the repetier host firmware and software. Everything is calibrated correctly but when printing the infill starts going crazy and goes to the end of the axis. (See photo of failed print). Does anyone know what is wrong please? I think it is a problem with Slic3r! Thanks! https://reprap.org/forum/read.php?262,572648,572648#msg-572648 Fri, 07 Aug 2026 07:32:33 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?262,572648,572747#msg-572747 https://reprap.org/forum/read.php?262,572648,572747#msg-572747 I found out just recently that I choose a very poorly my power supply, that you need 30A on the 12v channels to keep everything running at top speed.]]> aFrazatto Printing Mon, 19 Oct 2015 17:04:20 -0400 https://reprap.org/forum/read.php?262,572648,572669#msg-572669 https://reprap.org/forum/read.php?262,572648,572669#msg-572669 Montiey Printing Mon, 19 Oct 2015 14:24:23 -0400 https://reprap.org/forum/read.php?262,572648,572655#msg-572655 https://reprap.org/forum/read.php?262,572648,572655#msg-572655 gomme600 Printing Mon, 19 Oct 2015 13:37:01 -0400 https://reprap.org/forum/read.php?262,572648,572649#msg-572649 https://reprap.org/forum/read.php?262,572648,572649#msg-572649 Floyd Printing Mon, 19 Oct 2015 13:23:40 -0400 https://reprap.org/forum/read.php?262,572648,572648#msg-572648 https://reprap.org/forum/read.php?262,572648,572648#msg-572648 gomme600 Printing Mon, 19 Oct 2015 13:20:25 -0400