Hallo! I use a Geeetech Rumba control cards. When the printer is printing, the first contours is OK, but when the printer starts to make a filling, between contours, is it as if X and Y change place, and the printer goes in a completely different direction than it should. Eventually it reaches the end positions. Does anyone know what is incorrect. AndOsb https://reprap.org/forum/read.php?262,584641,584641#msg-584641 Mon, 20 Apr 2026 21:32:19 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?262,584641,585417#msg-585417 https://reprap.org/forum/read.php?262,584641,585417#msg-585417 It seems as, if it is going in (+X,+Y) direction, it works all right, but when it should go in (-X,-Y) just -X works.
I have tested to print a 3D-figure with 8 corners, and that works OK in all 8 directions, when it writes the contour.]]> AndOsb Printing Tue, 17 Nov 2015 07:22:27 -0500 https://reprap.org/forum/read.php?262,584641,584881#msg-584881 https://reprap.org/forum/read.php?262,584641,584881#msg-584881 imqqmi Printing Mon, 16 Nov 2015 03:51:57 -0500 https://reprap.org/forum/read.php?262,584641,584641#msg-584641 https://reprap.org/forum/read.php?262,584641,584641#msg-584641
I use a Geeetech Rumba control cards. When the printer is printing, the first contours is OK,
but when the printer starts to make a filling, between contours, is it as if X and Y change place,
and the printer goes in a completely different direction than it should. Eventually it reaches the end positions.
Does anyone know what is incorrect.

AndOsb]]> AndOsb Printing Sun, 15 Nov 2015 11:35:06 -0500