Hey, I am wondering if there is any way to use a Filament runout sensor without an LCD-Panel. My firmware (Marlin 1.0.3) already has a function for this (M600), but it only works in combination with a LCD-Panel. I would like to have a solution to use a filament runout sensor with my host-PC (Simplify3D or Repetier-Host). So far I havent found a working solution. I have added a sensor and set the pins.h accordingly. I just ran out of ideas about what should happen, once the sensor is activated (filament runout). Any ideas/Solutions? Thanks in advance https://reprap.org/forum/read.php?262,594213,594213#msg-594213 Sat, 11 Jul 2026 20:29:43 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?262,594213,594213#msg-594213 https://reprap.org/forum/read.php?262,594213,594213#msg-594213
I am wondering if there is any way to use a Filament runout sensor without an LCD-Panel.
My firmware (Marlin 1.0.3) already has a function for this (M600), but it only works in combination with a LCD-Panel.
I would like to have a solution to use a filament runout sensor with my host-PC (Simplify3D or Repetier-Host). So far I havent found a working solution.
I have added a sensor and set the pins.h accordingly. I just ran out of ideas about what should happen, once the sensor is activated (filament runout).

Any ideas/Solutions?

Thanks in advance]]> Eistee Printing Tue, 08 Dec 2015 06:11:02 -0500