Print moves few mm to the left then back to where it should be cant find thee problem need help desperately

Print moves few mm to the left then back to where it should be cant find thee problem need help desperately I cant remember if i printed any thing tall before but i just noticed this, unfortunately its not a RepRap but its a GeeTech Me Creator but i figured id give this a shot since im having trouble at the Geetech forums. any ways i finally got to print stuff good but but at a certain height the print moves about 2mm for about a 5mm height and then goes back to its original position it should be. i used to use cura so i even tried switching to slic3r, and then thee printer came with board so i thought it could be the board and i changed it to the ramps 1.4 but the problem was still there so i went back to the original controller because i like the single board. i made sure all the screws are tight and are intact belt tension is good and the z axis threaded rod seems to be fairly straight at least to the naked eye and i even tried printout any tension on the top of the rod so if it is bent it will move the rod instead of the two rods holding the bed straight. and also i turned thee rod upside down but still it misprints at the same spot. any help is appreciated and thanks in advance. (attached a pic to show whats happening) https://reprap.org/forum/read.php?262,629596,629596#msg-629596 Thu, 10 Sep 2026 09:41:57 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?262,629596,629900#msg-629900 Re: Print moves few mm to the left then back to where it should be cant find thee problem need help desperately https://reprap.org/forum/read.php?262,629596,629900#msg-629900 dnukeg Printing Sun, 21 Feb 2016 15:37:10 -0500 https://reprap.org/forum/read.php?262,629596,629746#msg-629746 Re: Print moves few mm to the left then back to where it should be cant find thee problem need help desperately https://reprap.org/forum/read.php?262,629596,629746#msg-629746 nebbian Printing Sun, 21 Feb 2016 09:28:33 -0500 https://reprap.org/forum/read.php?262,629596,629687#msg-629687 Re: Print moves few mm to the left then back to where it should be cant find thee problem need help desperately https://reprap.org/forum/read.php?262,629596,629687#msg-629687 the_digital_dentist Printing Sun, 21 Feb 2016 07:34:15 -0500 https://reprap.org/forum/read.php?262,629596,629596#msg-629596 Print moves few mm to the left then back to where it should be cant find thee problem need help desperately https://reprap.org/forum/read.php?262,629596,629596#msg-629596
(attached a pic to show whats happening)]]> dnukeg Printing Sun, 21 Feb 2016 02:31:01 -0500