has anyone found a way to prevent the ooze from sticking to the model with a chimera? so far I've managed to minimized the mess to almost a clean print by increasing the retraction speed to 50mm/s at 16mm retraction at 185c, any lower on temp I end up with under extrusion unless maybe I lower the print speed, which isn't ideal ooze is not really a solution to this as it mostly get dragged over to the model after certain height all things I've tried I was using cura in repetier host I will try sli3er tomorrow with skirt at same height as the model and see how that goes any suggestions? https://reprap.org/forum/read.php?262,699912,699912#msg-699912 Thu, 15 Oct 2026 07:37:59 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?262,699912,699998#msg-699998 https://reprap.org/forum/read.php?262,699912,699998#msg-699998 deaconfrost Printing Sun, 14 Aug 2016 12:03:01 -0400 https://reprap.org/forum/read.php?262,699912,699944#msg-699944 https://reprap.org/forum/read.php?262,699912,699944#msg-699944 deckingman Printing Sun, 14 Aug 2016 04:58:27 -0400 https://reprap.org/forum/read.php?262,699912,699912#msg-699912 https://reprap.org/forum/read.php?262,699912,699912#msg-699912
so far I've managed to minimized the mess to almost a clean print by increasing the retraction speed to 50mm/s at 16mm retraction at 185c, any lower on temp I end up with under extrusion unless maybe I lower the print speed, which isn't ideal

ooze is not really a solution to this as it mostly get dragged over to the model after certain height

all things I've tried I was using cura in repetier host

I will try sli3er tomorrow with skirt at same height as the model and see how that goes

any suggestions?]]> deaconfrost Printing Sat, 13 Aug 2016 22:13:06 -0400