here is my problem. My printer can print ABS fine, when I load my PLA in it extruders for about 30 seconds then jams in the hotend. I think the PLA is melting too early in the barrel. Any thoughts? https://reprap.org/forum/read.php?262,705204,705204#msg-705204 Wed, 15 Jul 2026 16:09:59 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?262,705204,706018#msg-706018 https://reprap.org/forum/read.php?262,705204,706018#msg-706018 sick_layer Printing Thu, 08 Sep 2016 07:34:32 -0400 https://reprap.org/forum/read.php?262,705204,705350#msg-705350 https://reprap.org/forum/read.php?262,705204,705350#msg-705350 DaGameFace Printing Mon, 05 Sep 2016 11:05:11 -0400 https://reprap.org/forum/read.php?262,705204,705216#msg-705216 https://reprap.org/forum/read.php?262,705204,705216#msg-705216 ggherbaz Printing Sun, 04 Sep 2016 22:04:22 -0400 https://reprap.org/forum/read.php?262,705204,705204#msg-705204 https://reprap.org/forum/read.php?262,705204,705204#msg-705204 JMAPsci Printing Sun, 04 Sep 2016 19:49:25 -0400