Hi Anyony have a advice about how to Clean the nozzle for PLA ? I remove the nozzle with the heater on, not possible on Cold heater. The nozzle is after that full of PLA and it get hard quickly. So, best tips for removing the PLA? Thanks https://reprap.org/forum/read.php?262,804599,804599#msg-804599 Wed, 16 Sep 2026 21:33:12 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?262,804599,804608#msg-804608 https://reprap.org/forum/read.php?262,804599,804608#msg-804608
Basically you heat up the tip to near printing temp then pull the filament out quick, it clears alot from the tip all the way up.

then removing the tip cold is pretty easy as most of the plastic is out of there...]]> JustSumGuy Printing Tue, 09 Jan 2018 14:51:43 -0500 https://reprap.org/forum/read.php?262,804599,804599#msg-804599 https://reprap.org/forum/read.php?262,804599,804599#msg-804599 Anyony have a advice about how to Clean the nozzle for PLA ?
I remove the nozzle with the heater on, not possible on Cold heater.
The nozzle is after that full of PLA and it get hard quickly.
So, best tips for removing the PLA?
Thanks]]> hokanp Printing Tue, 09 Jan 2018 14:23:58 -0500