pic Hopefully that url works... I've been having this issue for awhile, but not sure of cause. I would love any and all thoughts please. I'm using t2.5 for my timing belts, which I hear is rather out of date and should be upgraded... Not sure if that could be the cause here? Thank you all https://reprap.org/forum/read.php?262,806367,806367#msg-806367 Sun, 09 Aug 2026 19:09:16 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?262,806367,806384#msg-806384 https://reprap.org/forum/read.php?262,806367,806384#msg-806384
I would also check and re-calibrate the extruder. It looks like is not always extruding as much as it should. It could also be slicing related. Going too fast around small perimeters etc.

Many variables, but temperature and extruder calibration would be my guess.

Good luck.]]> v1talogy Printing Sat, 20 Jan 2018 02:11:37 -0500 https://reprap.org/forum/read.php?262,806367,806378#msg-806378 https://reprap.org/forum/read.php?262,806367,806378#msg-806378 kickinthethroat Printing Sat, 20 Jan 2018 00:16:40 -0500 https://reprap.org/forum/read.php?262,806367,806371#msg-806371 https://reprap.org/forum/read.php?262,806367,806371#msg-806371 Roberts_Clif Printing Fri, 19 Jan 2018 22:34:06 -0500 https://reprap.org/forum/read.php?262,806367,806367#msg-806367 https://reprap.org/forum/read.php?262,806367,806367#msg-806367 pic

Hopefully that url works...

I've been having this issue for awhile, but not sure of cause. I would love any and all thoughts please.

I'm using t2.5 for my timing belts, which I hear is rather out of date and should be upgraded... Not sure if that could be the cause here?

Thank you all]]> kickinthethroat Printing Fri, 19 Jan 2018 21:12:00 -0500