I've got a part here, I'd noted that shrinkage issues persist near the build plate (at 115 DegC) so, heck lets flip it around and allow distortion where it does not matter so much on the part! Here are some results of that, generally good but the shrinkage is pronounced. Any pointers or insights? It is printed in an enclosed chamber at 235 DegC head temp and the chamber is about 35-38 DegC. [attachment 118258 carriage_side_abs.jpg] [attachment 118259 carriage_bottom.jpg] https://reprap.org/forum/read.php?262,884086,884086#msg-884086 Mon, 11 May 2026 13:57:36 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?262,884086,884354#msg-884354 https://reprap.org/forum/read.php?262,884086,884354#msg-884354 Dirty Steve Printing Wed, 26 May 2021 16:04:20 -0400 https://reprap.org/forum/read.php?262,884086,884216#msg-884216 https://reprap.org/forum/read.php?262,884086,884216#msg-884216 or you may change filament from another manufacturer for a try.]]> Annabel Printing Fri, 21 May 2021 03:00:35 -0400 https://reprap.org/forum/read.php?262,884086,884090#msg-884090 https://reprap.org/forum/read.php?262,884086,884090#msg-884090 the_digital_dentist Printing Fri, 14 May 2021 21:48:37 -0400 https://reprap.org/forum/read.php?262,884086,884089#msg-884089 https://reprap.org/forum/read.php?262,884086,884089#msg-884089
Nozzle Temp ( at 232 DegC )
build plate (at 96 DegC)
Enclosed chamber 35-38 DegC

I 3D Printed every part for the MPCNC carriage with every part fitting perfectly together.

[attachment 118260 carriage.jpg]]]> Roberts_Clif Printing Fri, 14 May 2021 21:03:18 -0400 https://reprap.org/forum/read.php?262,884086,884086#msg-884086 https://reprap.org/forum/read.php?262,884086,884086#msg-884086
Here are some results of that, generally good but the shrinkage is pronounced. Any pointers or insights?

It is printed in an enclosed chamber at 235 DegC head temp and the chamber is about 35-38 DegC.

[attachment 118258 carriage_side_abs.jpg]
[attachment 118259 carriage_bottom.jpg]]]> NovaHuta Printing Fri, 14 May 2021 17:11:58 -0400