causes all sorts of problems, it can sometimes take 5 layers to get a nice solid layer, depending on the thickness of your layers. not only does it leave holes but it can also drag through when the filament has curled up where it's broken. maybe if it's calculated as bridges it would help? in the past I've sometimes cut and spliced different fill amounts to get a higher fill pattern ontop of a lower one before a solid layer which helps. https://reprap.org/forum/read.php?263,131788,131788#msg-131788 Thu, 10 Sep 2026 06:14:30 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?263,131788,131825#msg-131825 https://reprap.org/forum/read.php?263,131788,131825#msg-131825 0.2mm layers infill every 2 layers (so infill was 0.4mm... were the solid layers 0.4 or 0.2?...)

I might print that bridge calabration test thing and see how that comes out.]]> se5a Slic3r Tue, 08 May 2012 01:02:29 -0400 https://reprap.org/forum/read.php?263,131788,131806#msg-131806 https://reprap.org/forum/read.php?263,131788,131806#msg-131806 I'll try 50mm/s for that instead of the 100 I've been doing.]]> se5a Slic3r Mon, 07 May 2012 21:18:08 -0400 https://reprap.org/forum/read.php?263,131788,131804#msg-131804 https://reprap.org/forum/read.php?263,131788,131804#msg-131804 Sublime Slic3r Mon, 07 May 2012 20:55:37 -0400 https://reprap.org/forum/read.php?263,131788,131802#msg-131802 https://reprap.org/forum/read.php?263,131788,131802#msg-131802 how else would I change the 'stretching'?
extrusion width is set to automatic, if anything I'm over extruding slightly. temp? up? down?]]> se5a Slic3r Mon, 07 May 2012 20:48:20 -0400 https://reprap.org/forum/read.php?263,131788,131797#msg-131797 https://reprap.org/forum/read.php?263,131788,131797#msg-131797 nophead Slic3r Mon, 07 May 2012 19:52:44 -0400 https://reprap.org/forum/read.php?263,131788,131790#msg-131790 https://reprap.org/forum/read.php?263,131788,131790#msg-131790 Sublime Slic3r Mon, 07 May 2012 18:55:34 -0400 https://reprap.org/forum/read.php?263,131788,131788#msg-131788 https://reprap.org/forum/read.php?263,131788,131788#msg-131788 not only does it leave holes but it can also drag through when the filament has curled up where it's broken.
maybe if it's calculated as bridges it would help?

in the past I've sometimes cut and spliced different fill amounts to get a higher fill pattern ontop of a lower one before a solid layer which helps.]]> se5a Slic3r Mon, 07 May 2012 18:45:03 -0400