I'll try my best to explain this but I've printed the same parts before but recently recreated the GCode using the Current version of Slic3r. Interestingly what it seems to be doing is do the 1 line at one end of the bridge then another at the other end, then it tries to fill the bridge by joining the two lines in the opposite direction as such it fails. I know it used to do the first layer of the bridge in one direction and now its only doing the ends and then trying to fill it in which isn't going to work with two thin strands of plastic. Any thoughts? https://reprap.org/forum/read.php?263,133132,133132#msg-133132 Mon, 05 Oct 2026 13:36:39 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?263,133132,136472#msg-136472 https://reprap.org/forum/read.php?263,133132,136472#msg-136472 Triffid_Hunter Slic3r Wed, 06 Jun 2012 10:04:39 -0400 https://reprap.org/forum/read.php?263,133132,133166#msg-133166 https://reprap.org/forum/read.php?263,133132,133166#msg-133166 bmsweb Slic3r Wed, 16 May 2012 22:50:39 -0400 https://reprap.org/forum/read.php?263,133132,133139#msg-133139 https://reprap.org/forum/read.php?263,133132,133139#msg-133139 bmsweb Slic3r Wed, 16 May 2012 19:37:58 -0400 https://reprap.org/forum/read.php?263,133132,133134#msg-133134 https://reprap.org/forum/read.php?263,133132,133134#msg-133134 Sublime Slic3r Wed, 16 May 2012 19:02:45 -0400 https://reprap.org/forum/read.php?263,133132,133132#msg-133132 https://reprap.org/forum/read.php?263,133132,133132#msg-133132
Any thoughts?]]> bmsweb Slic3r Wed, 16 May 2012 19:00:22 -0400