I noticed a difference between the skeinforge slicing and slic3r and think it may make a nice addition if possible to Slic3r. When I print on my makerbot with replicatorg it actually follows a perimeter when moving from one location to another and not printing. I think this helps a lot with stringing created during non printing moves because any stringing that is created is actually on the inside of a print. Slic3r seems to move from point a to b in a direct line (which is not bad for speed). Maybe an optional flag that will have it follow the inner perimeter when going from a to b during a non print move would be nice? https://reprap.org/forum/read.php?263,166104,166104#msg-166104 Thu, 14 May 2026 03:56:26 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?263,166104,166114#msg-166114 https://reprap.org/forum/read.php?263,166104,166114#msg-166114 Dirty Steve Slic3r Wed, 14 Nov 2012 12:44:46 -0500 https://reprap.org/forum/read.php?263,166104,166106#msg-166106 https://reprap.org/forum/read.php?263,166104,166106#msg-166106 github.com]]]> crispy1 Slic3r Wed, 14 Nov 2012 11:49:52 -0500 https://reprap.org/forum/read.php?263,166104,166104#msg-166104 https://reprap.org/forum/read.php?263,166104,166104#msg-166104 jamesarm97b Slic3r Wed, 14 Nov 2012 11:33:41 -0500