I just tried printing 5 objects when calibrating the printer and i noticed that slicer first printed the inner perimeter (a hollow cube with 3 perimeters) for all 5 objects, then the middle for all 5 objects and last the external perimeter for each layer. Is there any valid reason to do it this way instead of finishing the layer for one object at a time? Btw I'm using slicer 0.9.10b https://reprap.org/forum/read.php?263,263447,263447#msg-263447 Sat, 12 Sep 2026 01:27:23 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?263,263447,264904#msg-264904 https://reprap.org/forum/read.php?263,263447,264904#msg-264904 the_digital_dentist Slic3r Sun, 10 Nov 2013 08:44:57 -0500 https://reprap.org/forum/read.php?263,263447,264418#msg-264418 https://reprap.org/forum/read.php?263,263447,264418#msg-264418 waitaki Slic3r Fri, 08 Nov 2013 18:31:18 -0500 https://reprap.org/forum/read.php?263,263447,264352#msg-264352 https://reprap.org/forum/read.php?263,263447,264352#msg-264352 nikbjo Slic3r Fri, 08 Nov 2013 15:08:21 -0500 https://reprap.org/forum/read.php?263,263447,263753#msg-263753 https://reprap.org/forum/read.php?263,263447,263753#msg-263753
If you want to see what would happen print a 10mm cube (just one) and make sure cooling is turned off. The base will be ok but further up the cube it will start to just push around already laid down plastic until it no longer looks like a cube.]]> tmorris9 Slic3r Wed, 06 Nov 2013 16:00:23 -0500 https://reprap.org/forum/read.php?263,263447,263447#msg-263447 https://reprap.org/forum/read.php?263,263447,263447#msg-263447
Btw I'm using slicer 0.9.10b]]> nikbjo Slic3r Tue, 05 Nov 2013 15:12:28 -0500