I've been facing this problem for two days that the infill changes that i make dont get applied. the printer prints at 100 rectilinear and only the first layer changes takes place. The solid infill is always rectilinear. i've restarted my system, downloaded new slic3r but of no use. what should i do ? https://reprap.org/forum/read.php?263,476102,476102#msg-476102 Wed, 13 May 2026 03:46:31 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?263,476102,476159#msg-476159 https://reprap.org/forum/read.php?263,476102,476159#msg-476159 2) IIRC the top & bottom solid infill patterns are only applied to the outer (top & bottom) single layers because they are purely for cosmetic purposes - all other top & bottom solid layers will be rectilinear.
3) If the top surface does not have a fairly large flat horizontal surface, the top infill pattern may not show up (e.g. on a dome, pyramid or sloping top).

Dave]]> dmould Slic3r Thu, 26 Feb 2015 12:00:22 -0500 https://reprap.org/forum/read.php?263,476102,476102#msg-476102 https://reprap.org/forum/read.php?263,476102,476102#msg-476102 prateektyagi Slic3r Thu, 26 Feb 2015 09:13:49 -0500