When I got my new filament, NinjaFlex, I had to bring down the extrude speed to 25mm/s. After that I went into Slic3r to change the speed settings to 25mm/s. After I sliced it like normal, except it gave me a really odd finishing time. So I double checked it and compared the times to another config that had the speed at 60mm/s. When i sliced it, the times were roughly the same(20 minute difference). I was wondering how I could fix the speed so it truly reflect the 25mm/s speed. Thanks :) https://reprap.org/forum/read.php?263,492913,492913#msg-492913 Fri, 12 Jun 2026 10:14:25 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?263,492913,493172#msg-493172 https://reprap.org/forum/read.php?263,492913,493172#msg-493172 Pandanator Slic3r Sun, 05 Apr 2015 14:25:01 -0400 https://reprap.org/forum/read.php?263,492913,493171#msg-493171 https://reprap.org/forum/read.php?263,492913,493171#msg-493171 Pandanator Slic3r Sun, 05 Apr 2015 14:25:01 -0400 https://reprap.org/forum/read.php?263,492913,493106#msg-493106 https://reprap.org/forum/read.php?263,492913,493106#msg-493106 IMBoring25 Slic3r Sun, 05 Apr 2015 11:39:02 -0400 https://reprap.org/forum/read.php?263,492913,493100#msg-493100 https://reprap.org/forum/read.php?263,492913,493100#msg-493100 www.thingiverse.com]. I scaled that to 3 and sliced at .2mm.]]> Pandanator Slic3r Sun, 05 Apr 2015 11:00:39 -0400 https://reprap.org/forum/read.php?263,492913,492944#msg-492944 https://reprap.org/forum/read.php?263,492913,492944#msg-492944
How big are the slices of the part you're printing and what are your cooling settings? If it's a part with small layer cross-sections and you have a conservative minimum layer time, you might already be at less than 25 mm/s.]]> IMBoring25 Slic3r Sun, 05 Apr 2015 00:46:14 -0400 https://reprap.org/forum/read.php?263,492913,492913#msg-492913 https://reprap.org/forum/read.php?263,492913,492913#msg-492913 Pandanator Slic3r Sat, 04 Apr 2015 20:50:54 -0400