Hey everyone, I am new to 3D-printing and worked with slic3r to create a simple cylinder with a grid structure. The problem I am having now is that when the g-code is generated somehow the instructions for turning off printing when travelling to a new location are missing. I created a commented g-code (both attached, settings for the print may vary), in which you can see where the extruder retracts, so I could manually input the commands but that is too inconvenient. Can somebody help? https://reprap.org/forum/read.php?263,884927,884927#msg-884927 Sun, 16 Aug 2026 21:06:38 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?263,884927,885003#msg-885003 https://reprap.org/forum/read.php?263,884927,885003#msg-885003 I searched in the print & printer settings and found options for retraction but nothing about turning the print on/off.
So the print still doesn´t stop when the printhead is retracting. :(
(And yes, I am using Slic3r)]]> Klara Slic3r Tue, 13 Jul 2021 08:12:12 -0400 https://reprap.org/forum/read.php?263,884927,884977#msg-884977 https://reprap.org/forum/read.php?263,884927,884977#msg-884977 dustinoff Slic3r Sun, 11 Jul 2021 20:22:55 -0400 https://reprap.org/forum/read.php?263,884927,884927#msg-884927 https://reprap.org/forum/read.php?263,884927,884927#msg-884927
I am new to 3D-printing and worked with slic3r to create a simple cylinder with a grid structure. The problem I am having now is that when the g-code is generated somehow the instructions for turning off printing when travelling to a new location are missing. I created a commented g-code (both attached, settings for the print may vary), in which you can see where the extruder retracts, so I could manually input the commands but that is too inconvenient.
Can somebody help?]]> Klara Slic3r Wed, 07 Jul 2021 06:43:35 -0400