Attempting to print an organizer....that holds pens, tv remote, etc. ISSUE: Additional thin wall is created by Slic3r that is unwanted. It is NOT in the 3D model. I have attached the following: - STL file - 2 screenshots showing the model prior to and after slicing that shows the issue at hand. - 1 screenshot showing the Print Settings in Slic3r. If I uncheck Print Settings / Advanced / Fill gaps then it removes the unwanted wall but then many the short 3 mm walls are missing tops. I've included a screenshot of the post slice with this setting off. Any ideas anyone? https://reprap.org/forum/read.php?263,888051,888051#msg-888051 Mon, 10 Aug 2026 12:31:27 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?263,888051,888051#msg-888051 https://reprap.org/forum/read.php?263,888051,888051#msg-888051
ISSUE: Additional thin wall is created by Slic3r that is unwanted. It is NOT in the 3D model.

I have attached the following:
- STL file
- 2 screenshots showing the model prior to and after slicing that shows the issue at hand.
- 1 screenshot showing the Print Settings in Slic3r.

If I uncheck Print Settings / Advanced / Fill gaps then it removes the unwanted wall but then many the short 3 mm walls are missing tops. I've included a screenshot of the post slice with this setting off.

Any ideas anyone?]]> miket83706 Slic3r Tue, 25 Jan 2022 00:36:47 -0500