I need to change the laser cut frame a bit because I don't have access to 6mm stock. This is probably a stupid question, but how do I reexport the stl files from blender? I assume they came from this layer, but I can't figure out how to export the edges only. [attachment 15033 tantillus_lc_frame_blender] https://reprap.org/forum/read.php?279,209325,209325#msg-209325 Mon, 05 Oct 2026 14:22:45 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?279,209325,209627#msg-209627 https://reprap.org/forum/read.php?279,209325,209627#msg-209627 Sublime Tantillus Fri, 17 May 2013 15:18:21 -0400 https://reprap.org/forum/read.php?279,209325,209621#msg-209621 https://reprap.org/forum/read.php?279,209325,209621#msg-209621 lajos Tantillus Fri, 17 May 2013 15:09:57 -0400 https://reprap.org/forum/read.php?279,209325,209537#msg-209537 https://reprap.org/forum/read.php?279,209325,209537#msg-209537 Sublime Tantillus Fri, 17 May 2013 11:38:38 -0400 https://reprap.org/forum/read.php?279,209325,209506#msg-209506 https://reprap.org/forum/read.php?279,209325,209506#msg-209506
The step I couldn't figure out was actually how you exported the stls from blender. Although with inkscape I don't need new stls.]]> lajos Tantillus Fri, 17 May 2013 10:44:15 -0400 https://reprap.org/forum/read.php?279,209325,209328#msg-209328 https://reprap.org/forum/read.php?279,209325,209328#msg-209328
It would be easier to use a 2D program to change the drawings then to go the STL route. Inkscape can edit the DXF's and is opensource and cross platform. Draftsight which is free closed source and cross platform can also do it. I am sure there are more as well.]]> Sublime Tantillus Thu, 16 May 2013 22:09:39 -0400 https://reprap.org/forum/read.php?279,209325,209325#msg-209325 https://reprap.org/forum/read.php?279,209325,209325#msg-209325
[attachment 15033 tantillus_lc_frame_blender]]]> lajos Tantillus Thu, 16 May 2013 21:57:46 -0400