I apologize if this isn't the most relevant question for this forum but I was hoping someone might know how to repair fractures along layers in a PLA print. I've heard super glue is a good option but does anyone know a method that works well? Thanks! https://reprap.org/forum/read.php?279,387442,387442#msg-387442 Tue, 14 Jul 2026 12:22:10 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?279,387442,388455#msg-388455 https://reprap.org/forum/read.php?279,387442,388455#msg-388455 Nick101 Tantillus Mon, 28 Jul 2014 11:41:11 -0400 https://reprap.org/forum/read.php?279,387442,387676#msg-387676 https://reprap.org/forum/read.php?279,387442,387676#msg-387676 swoozle Tantillus Fri, 25 Jul 2014 15:11:08 -0400 https://reprap.org/forum/read.php?279,387442,387470#msg-387470 https://reprap.org/forum/read.php?279,387442,387470#msg-387470 Sublime Tantillus Fri, 25 Jul 2014 02:49:46 -0400 https://reprap.org/forum/read.php?279,387442,387442#msg-387442 https://reprap.org/forum/read.php?279,387442,387442#msg-387442 Nick101 Tantillus Fri, 25 Jul 2014 00:56:50 -0400