Hi again crew! finally Foldarap 142 seems to be working but when it arrives to layer 20-25 de Z axis stops.... anyone with that kind of problem?? Z axis are working ok, i can move the hotend using manual controls in Repetier Host but when 142 is printing z movement stops after 20 layers... Thanks as always!! https://reprap.org/forum/read.php?283,351169,351169#msg-351169 Wed, 22 Jul 2026 06:37:43 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?283,351169,352936#msg-352936 https://reprap.org/forum/read.php?283,351169,352936#msg-352936
I not sure to understand your problem. But if its what I think here is my solution :

I build my foldarap as shown here : but without the screw blocking the hinges (unlike there)

So when I added the top frame, the 2 Z extruded bars where not parallel.

What I suggest you to do, his to untighten the srew of the top frame and the screws of the Z sliders (connecting Z sliders to the X axis extruded bar) and move the extruder on the Z axis. It wont stop anymore.

Then you can tighten the screws

I hope this will help you ;)]]> mattsi FoldaRap Fri, 09 May 2014 12:10:25 -0400 https://reprap.org/forum/read.php?283,351169,351493#msg-351493 https://reprap.org/forum/read.php?283,351169,351493#msg-351493 majic79 FoldaRap Wed, 07 May 2014 05:55:24 -0400 https://reprap.org/forum/read.php?283,351169,351169#msg-351169 https://reprap.org/forum/read.php?283,351169,351169#msg-351169
finally Foldarap 142 seems to be working but when it arrives to layer 20-25 de Z axis stops....

anyone with that kind of problem??

Z axis are working ok, i can move the hotend using manual controls in Repetier Host but when 142 is printing z movement stops after 20 layers...


Thanks as always!!]]> nachetz FoldaRap Tue, 06 May 2014 12:04:26 -0400