Recently ordered a new kit and the aluminum tube inserts snap almost immediately, leaving the nyloc nut spinning uselessly inside the tube. It's then almost impossible to get it off the screw, so I now have the tubes barely attached to the base dibond sheet and no way to remove them or tighten them. Any ideas? https://reprap.org/forum/read.php?292,304519,304519#msg-304519 Wed, 07 Oct 2026 20:43:17 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?292,304519,305336#msg-305336 https://reprap.org/forum/read.php?292,304519,305336#msg-305336 cdru Mendel90 Mon, 03 Feb 2014 09:21:13 -0500 https://reprap.org/forum/read.php?292,304519,304793#msg-304793 https://reprap.org/forum/read.php?292,304519,304793#msg-304793 Nilez Mendel90 Sun, 02 Feb 2014 08:55:44 -0500 https://reprap.org/forum/read.php?292,304519,304537#msg-304537 https://reprap.org/forum/read.php?292,304519,304537#msg-304537 BrianC Mendel90 Sat, 01 Feb 2014 15:25:23 -0500 https://reprap.org/forum/read.php?292,304519,304519#msg-304519 https://reprap.org/forum/read.php?292,304519,304519#msg-304519 BrianC Mendel90 Sat, 01 Feb 2014 14:57:41 -0500