Print Problems / Slice Settings Hi Guys I have not used my Mendel90 for a couple of months due to work. Last weekend I spent some time getting it back up and running. Essentially it's just sat dormant, so I cleaned it up and checked it all over. I need to print another Wades Idler Block as the current one has a small crack in it. But the prints are coming out poor. See the attached pic: [attachment 29468 layers1.jpg] I've played with the settings a lot in Skeinforge and I can't work out why this is happening? Tried 3 types of filament (all PLA). Tried extruder temps 180-195 degrees. The part sticks well to the glass/kapton bed at 50 degrees. Any ideas on what I can try next? https://reprap.org/forum/read.php?292,331019,331019#msg-331019 Fri, 09 Oct 2026 19:04:19 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?292,331019,331354#msg-331354 Re: Print Problems / Slice Settings https://reprap.org/forum/read.php?292,331019,331354#msg-331354 nophead Mendel90 Fri, 28 Mar 2014 12:21:41 -0400 https://reprap.org/forum/read.php?292,331019,331320#msg-331320 Re: Print Problems / Slice Settings https://reprap.org/forum/read.php?292,331019,331320#msg-331320
hope it helps]]> klayus Mendel90 Fri, 28 Mar 2014 10:36:39 -0400 https://reprap.org/forum/read.php?292,331019,331166#msg-331166 Re: Print Problems / Slice Settings https://reprap.org/forum/read.php?292,331019,331166#msg-331166 IntelliTom Mendel90 Fri, 28 Mar 2014 05:22:15 -0400 https://reprap.org/forum/read.php?292,331019,331061#msg-331061 Re: Print Problems / Slice Settings https://reprap.org/forum/read.php?292,331019,331061#msg-331061 nophead Mendel90 Thu, 27 Mar 2014 21:37:36 -0400 https://reprap.org/forum/read.php?292,331019,331019#msg-331019 Print Problems / Slice Settings https://reprap.org/forum/read.php?292,331019,331019#msg-331019
I have not used my Mendel90 for a couple of months due to work. Last weekend I spent some time getting it back up and running. Essentially it's just sat dormant, so I cleaned it up and checked it all over.

I need to print another Wades Idler Block as the current one has a small crack in it. But the prints are coming out poor. See the attached pic:

[attachment 29468 layers1.jpg]

I've played with the settings a lot in Skeinforge and I can't work out why this is happening? Tried 3 types of filament (all PLA). Tried extruder temps 180-195 degrees. The part sticks well to the glass/kapton bed at 50 degrees.

Any ideas on what I can try next?]]> IntelliTom Mendel90 Thu, 27 Mar 2014 18:49:12 -0400