Good morning, The other night night I completed the assembly of my Ormerod 2 and started the commissioning process. everything appeared to be fine until I got to the "Heated Bed" section. Unfortunately when I set the temp to 45C nothing appeared to happen, I re-red the instruction and nothing. I waited about 5 minutes but still nothing, am I just being impatient? or have to probably done something wrong? Thing that I have tried: Re read the assembly stages for: Heated bed assembly Checked the PCB for damage Checked the forums Google Re re read the assembly stages for: Heated bed assembly Re re read the Commissioning process But I cant seam to see anything that helps Please help :-) Ben https://reprap.org/forum/read.php?340,466209,466209#msg-466209 Mon, 12 Oct 2026 23:39:17 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?340,466209,467534#msg-467534 https://reprap.org/forum/read.php?340,466209,467534#msg-467534 NeilFrazerLX Ormerod Sat, 07 Feb 2015 17:15:38 -0500 https://reprap.org/forum/read.php?340,466209,466616#msg-466616 https://reprap.org/forum/read.php?340,466209,466616#msg-466616
I now have it working, the wire had sheared off inside the crimped fitting, so from the end it looked like it was still connected.]]> bjscuba135 Ormerod Thu, 05 Feb 2015 17:45:32 -0500 https://reprap.org/forum/read.php?340,466209,466531#msg-466531 https://reprap.org/forum/read.php?340,466209,466531#msg-466531 razzadazzas Ormerod Thu, 05 Feb 2015 14:50:14 -0500 https://reprap.org/forum/read.php?340,466209,466282#msg-466282 https://reprap.org/forum/read.php?340,466209,466282#msg-466282

I'm reading 21-25 C on the bed (so room temperature) and I'm not getting a light on the front of the PCB.

Ill have a look at the Duet light and the voltage when i get home.

Thanks
Ben]]> bjscuba135 Ormerod Thu, 05 Feb 2015 09:31:08 -0500 https://reprap.org/forum/read.php?340,466209,466242#msg-466242 https://reprap.org/forum/read.php?340,466209,466242#msg-466242
Dave]]> dmould Ormerod Thu, 05 Feb 2015 07:51:27 -0500 https://reprap.org/forum/read.php?340,466209,466209#msg-466209 https://reprap.org/forum/read.php?340,466209,466209#msg-466209
The other night night I completed the assembly of my Ormerod 2 and started the commissioning process. everything appeared to be fine until I got to the "Heated Bed" section.
Unfortunately when I set the temp to 45C nothing appeared to happen, I re-red the instruction and nothing. I waited about 5 minutes but still nothing, am I just being impatient? or have to probably done something wrong?


Thing that I have tried:
Re read the assembly stages for: Heated bed assembly
Checked the PCB for damage
Checked the forums
Google
Re re read the assembly stages for: Heated bed assembly
Re re read the Commissioning process


But I cant seam to see anything that helps
Please help :-)
Ben]]> bjscuba135 Ormerod Thu, 05 Feb 2015 06:55:15 -0500