hi! im haveing some trouble with my x axis offset. when i print big prints it prints outside the glas. anyone know how to fix this? https://reprap.org/forum/read.php?340,504635,504635#msg-504635 Tue, 06 Oct 2026 05:23:35 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?340,504635,505266#msg-505266 https://reprap.org/forum/read.php?340,504635,505266#msg-505266
1) Set the bed size in the slicing software. You can use a size of 200mm X 200mm (the Ormerod can actually print slightly bigger than that).
2) Halve each dimension to find the center - in this case 100,100
3) After homing the X & Y axis, position the nozzle over the exact center of the glass using the move buttons on Pronterface or the web interface.
4) Send the command "G92 X100 Y100" (or whatever the center point is if you have set a different bed size in the slicing software).

Your print will now be perfectly centered on the bed. To set it automatically, find the difference between the position of 100,100 after homing and the position that is reported after you have moved the nozzle to the real bed center, and alter the X and Y home positions (as set in the homing files) by that amount. Then check that after homing the command "G1 X100 Y100" moves the nozzle to the exact center of the bed.

Dave]]> dmould Ormerod Tue, 05 May 2015 07:37:09 -0400 https://reprap.org/forum/read.php?340,504635,504674#msg-504674 https://reprap.org/forum/read.php?340,504635,504674#msg-504674 M208. Ideally the nozzle should be at X=0 when it's at the corner of your glass plate. Also check the bed size in your slicer, it shouldn't be bigger than the glass actually is.

If you're using RRP's official firmware, you may also need to remove the "G92 X0" lines from homeall.g and homex.g after you've added the right M208 parameters to your config file.]]> chrishamm Ormerod Sun, 03 May 2015 12:41:15 -0400 https://reprap.org/forum/read.php?340,504635,504635#msg-504635 https://reprap.org/forum/read.php?340,504635,504635#msg-504635 im haveing some trouble with my x axis offset.
when i print big prints it prints outside the glas.

anyone know how to fix this?]]> denshine Ormerod Sun, 03 May 2015 11:24:20 -0400