So...thermistors. I just finished the last steps of calibrating my custom corexy 3d printer and then... I think the hotend thermistor is broken. When I turn the printer on the Full Graphic Smart Controller shows a min temp error. Any help would be greatly appreciated. Configuration.h is attached. https://reprap.org/forum/read.php?397,726134,726134#msg-726134 Tue, 06 Oct 2026 05:45:59 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?397,726134,726360#msg-726360 https://reprap.org/forum/read.php?397,726134,726360#msg-726360 the_digital_dentist CoreXY Machines Sun, 27 Nov 2016 22:58:05 -0500 https://reprap.org/forum/read.php?397,726134,726339#msg-726339 https://reprap.org/forum/read.php?397,726134,726339#msg-726339 MatthewHall CoreXY Machines Sun, 27 Nov 2016 19:20:54 -0500 https://reprap.org/forum/read.php?397,726134,726160#msg-726160 https://reprap.org/forum/read.php?397,726134,726160#msg-726160 Mikk36 CoreXY Machines Sun, 27 Nov 2016 04:19:11 -0500 https://reprap.org/forum/read.php?397,726134,726134#msg-726134 https://reprap.org/forum/read.php?397,726134,726134#msg-726134 MatthewHall CoreXY Machines Sat, 26 Nov 2016 20:03:25 -0500