Nozzle to low after auto bed level grrrrrr Hello all , Ik have some troubles with my nozzle hight . I adjusted the z off set with M851 and stored it with M500 and active with M501when i check with M503 it's correct . When i look in the eeprom settings i see it too . By checking G1 F60 Z0 it is spot on . When i start to print after the bed level it goes to far down , i go crazy . It doesn't matter if i work with Cura 4.4 or S3D it is all the same. My start script: G21 ; G28; G29 ; G92 E0 ; G1 Z0 ; G1 X100.0 E20 ; G92 E0; M117 Printing...; What goes wrong ?? I dont have mutch hair but by the end of the week i'm bald. I have BLtouch as probe. https://reprap.org/forum/read.php?397,867985,867985#msg-867985 Sun, 08 Mar 2026 14:31:57 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?397,867985,872984#msg-872984 Re: Nozzle to low after auto bed level grrrrrr https://reprap.org/forum/read.php?397,867985,872984#msg-872984 ruggb CoreXY Machines Sun, 24 May 2020 17:06:31 -0400 https://reprap.org/forum/read.php?397,867985,867985#msg-867985 Nozzle to low after auto bed level grrrrrr https://reprap.org/forum/read.php?397,867985,867985#msg-867985
Ik have some troubles with my nozzle hight . I adjusted the z off set with M851 and stored it with M500 and active with M501when i check with M503 it's correct . When i look in the eeprom settings i see it too . By checking G1 F60 Z0 it is spot on . When i start to print after the bed level it goes to far down , i go crazy . It doesn't matter if i work with Cura 4.4 or S3D it is all the same.

My start script:
G21 ;
G28;
G29 ;
G92 E0 ;
G1 Z0 ;
G1 X100.0 E20 ;
G92 E0;
M117 Printing...;

What goes wrong ?? I dont have mutch hair but by the end of the week i'm bald.
I have BLtouch as probe.]]> bulldogbob CoreXY Machines Sun, 23 Feb 2020 11:51:53 -0500