Gaps In Solid Fill I have a Printrbot LC + and have it dialed in really good. I can get very accurate, repeatable parts from it. But I have an issue with small gaps in the final fill layers. I have it set up for three solid fills in the top layers but I'm getting small gaps around the edge of things like internal details and the outside edge. Attached is a picture of my test piece. It's is 30mm X 20mm. It is a very difficult part to print and makes a good test/trouble shooting part. Any ideas? https://reprap.org/forum/read.php?4,217560,217560#msg-217560 Mon, 07 Sep 2026 02:13:05 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?4,217560,221178#msg-221178 Re: Gaps In Solid Fill https://reprap.org/forum/read.php?4,217560,221178#msg-221178
Both of you might want to take a look at Triffid's calibration guide. The E Steps Fine Tuning section is one I like.]]> appdev007 Reprappers Mon, 24 Jun 2013 12:33:37 -0400 https://reprap.org/forum/read.php?4,217560,219246#msg-219246 Re: Gaps In Solid Fill https://reprap.org/forum/read.php?4,217560,219246#msg-219246 kirkram Reprappers Mon, 17 Jun 2013 22:07:41 -0400 https://reprap.org/forum/read.php?4,217560,218066#msg-218066 Re: Gaps In Solid Fill https://reprap.org/forum/read.php?4,217560,218066#msg-218066
Also I've got some GT2 pulleys and belts on order which should resolve any backlash I'm experiencing.

Thanks for the comments.]]> RunnerDuck Reprappers Thu, 13 Jun 2013 16:34:39 -0400 https://reprap.org/forum/read.php?4,217560,217565#msg-217565 Re: Gaps In Solid Fill https://reprap.org/forum/read.php?4,217560,217565#msg-217565 Check your pulleys and belts.]]> Polygonhell Reprappers Tue, 11 Jun 2013 21:52:01 -0400 https://reprap.org/forum/read.php?4,217560,217560#msg-217560 Gaps In Solid Fill https://reprap.org/forum/read.php?4,217560,217560#msg-217560
I have it set up for three solid fills in the top layers but I'm getting small gaps around the edge of things like internal details and the outside edge.

Attached is a picture of my test piece. It's is 30mm X 20mm. It is a very difficult part to print and makes a good test/trouble shooting part.

Any ideas?]]> RunnerDuck Reprappers Tue, 11 Jun 2013 20:52:40 -0400