sanguinololu: i think something burned out?! I had to repair a crimp connector on my heatbed and when i connected everything and turned on the heatbed to print i realized that i had connected the things wrong! The smoke i saw coming from the board helped me to realize that.... Result: now when i turn the heat on to 60º for example it just keeps on going on and on...it just ignores the temperature i set, but it gives me the reading of the temperature on printrun like always. I´m guessing i need to replace something on the sanguinololu (1.3a) . My guess would be the mosfet, but since i don´t see nothing burned i would like to ask if that its probably the component to replace and/or if there is some way to check if it is ok? Cheers https://reprap.org/forum/read.php?4,235721,235721#msg-235721 Fri, 10 Jul 2026 06:36:57 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?4,235721,237086#msg-237086 Re: sanguinololu: i think something burned out?! https://reprap.org/forum/read.php?4,235721,237086#msg-237086 pdesigns Reprappers Sat, 17 Aug 2013 15:40:11 -0400 https://reprap.org/forum/read.php?4,235721,237001#msg-237001 Re: sanguinololu: i think something burned out?! https://reprap.org/forum/read.php?4,235721,237001#msg-237001
Looking at it closer the middle pin of the Mosfet has a little black spot.

When you say FET is it a short for Mosfet? How do i check the gate voltage/control pin? I guess i have to use the multimeter, my question is on what points?

Sorry for all the questions..

**also i just plugged my new panelolu2 and it does not show any info about a heatbed on the LCD. Don´t know if this info helps..

Paulo]]> pdesigns Reprappers Sat, 17 Aug 2013 10:18:11 -0400 https://reprap.org/forum/read.php?4,235721,236190#msg-236190 Re: sanguinololu: i think something burned out?! https://reprap.org/forum/read.php?4,235721,236190#msg-236190
Bryan]]> bryanandaimee Reprappers Thu, 15 Aug 2013 12:18:05 -0400 https://reprap.org/forum/read.php?4,235721,235721#msg-235721 sanguinololu: i think something burned out?! https://reprap.org/forum/read.php?4,235721,235721#msg-235721
Result: now when i turn the heat on to 60º for example it just keeps on going on and on...it just ignores the temperature i set, but it gives me the reading of the temperature on printrun like always.

I´m guessing i need to replace something on the sanguinololu (1.3a) . My guess would be the mosfet, but since i don´t see nothing burned i would like to ask if that its probably the component to replace and/or if there is some way to check if it is ok?

Cheers]]> pdesigns Reprappers Wed, 14 Aug 2013 09:00:21 -0400