Hi everyone Sorry if this question has already been asked but i have a prusa i3 with a j-head hotend using 1.75mm abs. Im currently using a bowden setup for the extruder but im having some print issues which i believe is caused, at least in part to the bowden setup, so im wanting to try a new extruder. Since im using 1.75mm filament i dont think i need a geared extruder so im wanting to use direct drive. Does anyone know / use any that are good? there are afew on thingiverse but im not sure which way to jump. Any suggections would be great Kind regards Chris https://reprap.org/forum/read.php?4,291575,291575#msg-291575 Sat, 12 Sep 2026 22:18:52 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?4,291575,365638#msg-365638 https://reprap.org/forum/read.php?4,291575,365638#msg-365638 CptanPanic Reprappers Thu, 05 Jun 2014 13:41:02 -0400 https://reprap.org/forum/read.php?4,291575,294104#msg-294104 https://reprap.org/forum/read.php?4,291575,294104#msg-294104
I printed one at it looks to test fit fine on my Makerfarm I3 - I have not tested it yet as I am in the middle of a
bunch of prints for my robotics team.]]> bytemedwb Reprappers Mon, 13 Jan 2014 15:54:00 -0500 https://reprap.org/forum/read.php?4,291575,293962#msg-293962 https://reprap.org/forum/read.php?4,291575,293962#msg-293962 www.thingiverse.com] it looks good however im worried that all the weight overhanging at the front may cause issues]]> matrix4721 Reprappers Mon, 13 Jan 2014 11:20:16 -0500 https://reprap.org/forum/read.php?4,291575,291911#msg-291911 https://reprap.org/forum/read.php?4,291575,291911#msg-291911 sungod3k Reprappers Thu, 09 Jan 2014 11:48:10 -0500 https://reprap.org/forum/read.php?4,291575,291575#msg-291575 https://reprap.org/forum/read.php?4,291575,291575#msg-291575 Sorry if this question has already been asked but i have a prusa i3 with a j-head hotend using 1.75mm abs. Im currently using a bowden setup for the extruder but im having some print issues which i believe is caused, at least in part to the bowden setup, so im wanting to try a new extruder. Since im using 1.75mm filament i dont think i need a geared extruder so im wanting to use direct drive. Does anyone know / use any that are good? there are afew on thingiverse but im not sure which way to jump.

Any suggections would be great

Kind regards
Chris]]> matrix4721 Reprappers Wed, 08 Jan 2014 19:15:32 -0500