Hello everyone. I am building a large format 3d printer and I am currently using the x-ends and carriage from the Prusa Mendel iteration 2 until I design and test my own. I am designing the z-motor mounts and rod holders, and I was wondering if anyone knew the distance between the center of the M8 threaded rod and the 8mm smooth rod for the x-ends. Thank you, any help appreciated! https://reprap.org/forum/read.php?4,338544,338544#msg-338544 Fri, 09 Oct 2026 09:16:32 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?4,338544,339929#msg-339929 https://reprap.org/forum/read.php?4,338544,339929#msg-339929 Anonymous User Reprappers Mon, 14 Apr 2014 18:42:42 -0400 https://reprap.org/forum/read.php?4,338544,338672#msg-338672 https://reprap.org/forum/read.php?4,338544,338672#msg-338672 Omega3D Reprappers Sat, 12 Apr 2014 00:41:57 -0400 https://reprap.org/forum/read.php?4,338544,338635#msg-338635 https://reprap.org/forum/read.php?4,338544,338635#msg-338635 waitaki Reprappers Fri, 11 Apr 2014 20:10:45 -0400 https://reprap.org/forum/read.php?4,338544,338610#msg-338610 https://reprap.org/forum/read.php?4,338544,338610#msg-338610 Omega3D Reprappers Fri, 11 Apr 2014 18:19:04 -0400 https://reprap.org/forum/read.php?4,338544,338606#msg-338606 https://reprap.org/forum/read.php?4,338544,338606#msg-338606 Anonymous User Reprappers Fri, 11 Apr 2014 18:12:24 -0400 https://reprap.org/forum/read.php?4,338544,338544#msg-338544 https://reprap.org/forum/read.php?4,338544,338544#msg-338544 Omega3D Reprappers Fri, 11 Apr 2014 16:20:52 -0400