I have two issues... Not sure if they are linked or not. #1: If I turn the bed on, the bed and the extruder both turn on until the temp is met by the bed. If I turn the extruder on, the extruder and bed turn on until the temp is met by the extruder. If i turn both on, they both go on until both temps are met... #2: Printing from the SD card or from Repetier Host (v1.60), the print stops after about layer 3-5 but never in the same spot. If using Repetier Host, the G code continues to upload and scroll but no response from the printer. The temp also continues to decline on the display Are these connected problems? What is my next step? I have already flashed and reloaded arduino as well as restart everything https://reprap.org/forum/read.php?4,593279,593279#msg-593279 Tue, 21 Jul 2026 03:22:07 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?4,593279,594098#msg-594098 https://reprap.org/forum/read.php?4,593279,594098#msg-594098 Outie Reprappers Mon, 07 Dec 2015 22:27:07 -0500 https://reprap.org/forum/read.php?4,593279,594047#msg-594047 https://reprap.org/forum/read.php?4,593279,594047#msg-594047 Outie Reprappers Mon, 07 Dec 2015 17:04:59 -0500 https://reprap.org/forum/read.php?4,593279,593399#msg-593399 https://reprap.org/forum/read.php?4,593279,593399#msg-593399 You might have some solder-bridges on the Ramps board or there are small solder balls ( remains from solder wave oven ) shorting out pins on the arduino board.

-Olaf]]> o_lampe Reprappers Sun, 06 Dec 2015 04:59:11 -0500 https://reprap.org/forum/read.php?4,593279,593325#msg-593325 https://reprap.org/forum/read.php?4,593279,593325#msg-593325 gmckee Reprappers Sat, 05 Dec 2015 22:45:33 -0500 https://reprap.org/forum/read.php?4,593279,593279#msg-593279 https://reprap.org/forum/read.php?4,593279,593279#msg-593279
#1: If I turn the bed on, the bed and the extruder both turn on until the temp is met by the bed. If I turn the extruder on, the extruder and bed turn on until the temp is met by the extruder. If i turn both on, they both go on until both temps are met...

#2: Printing from the SD card or from Repetier Host (v1.60), the print stops after about layer 3-5 but never in the same spot. If using Repetier Host, the G code continues to upload and scroll but no response from the printer. The temp also continues to decline on the display

Are these connected problems? What is my next step?

I have already flashed and reloaded arduino as well as restart everything]]> Outie Reprappers Sat, 05 Dec 2015 17:37:31 -0500