Not moving the whole way Hey guys, I have recently made a 3d printer with a ramps 1.4 and marlin. Everything including homing works magnificintly. However, when I move the x and y axis 200mm away from home, The axis stops in the middle of the printer and seems to not move anymore. I thought it was a problem with the steps setting in the firmware, so I changed the firmware according to Triffid Hunter's guide. Even after that, it doesn;t seem to go more. I calculated the steps per mm are x,y: 80 z: 2560 e: 94.31412 I'm using JK42HS34-1334AC stepper motors, and I do have jumpers underneath the motor drivers (If that matters). How can I fix this? https://reprap.org/forum/read.php?4,625814,625814#msg-625814 Sat, 10 Oct 2026 17:16:19 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?4,625814,626032#msg-626032 Re: Not moving the whole way https://reprap.org/forum/read.php?4,625814,626032#msg-626032 Putzer Reprappers Sat, 13 Feb 2016 16:50:21 -0500 https://reprap.org/forum/read.php?4,625814,625950#msg-625950 Re: Not moving the whole way https://reprap.org/forum/read.php?4,625814,625950#msg-625950
Do a M119 and check the endstop status, did the max endstops get triggered after the move? If they did, disable them in configuration.h. The define for that is right after the endstop pullup section.]]> stephenrc Reprappers Sat, 13 Feb 2016 12:58:14 -0500 https://reprap.org/forum/read.php?4,625814,625814#msg-625814 Not moving the whole way https://reprap.org/forum/read.php?4,625814,625814#msg-625814
I have recently made a 3d printer with a ramps 1.4 and marlin. Everything including homing works magnificintly. However, when I move the x and y axis 200mm away from home, The axis stops in the middle of the printer and seems to not move anymore. I thought it was a problem with the steps setting in the firmware, so I changed the firmware according to Triffid Hunter's guide. Even after that, it doesn;t seem to go more. I calculated the steps per mm are
x,y: 80
z: 2560
e: 94.31412

I'm using JK42HS34-1334AC stepper motors, and I do have jumpers underneath the motor drivers (If that matters).

How can I fix this?]]> vapark212 Reprappers Sat, 13 Feb 2016 08:03:02 -0500