I might have put this in the wrong section, so I'll just post the same topic again here. If anyone sees a thread with the same title somewhere else, delete it. So while everything about the printer works fine, the E-Motor is not moving the filament through the nozzle. I manually step it 1mm at a time and nothing comes out. The filament goes through just fine, so there's no clogging or expanding or anything, and the motor is running fine, but there is no friction between them. Can someone please help? i know I assembled it correctly (I upgraded to the MK8 Pro, so I dunno if that's any different.) https://reprap.org/forum/read.php?406,576252,576252#msg-576252 Sun, 09 Aug 2026 18:40:35 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?406,576252,576805#msg-576805 https://reprap.org/forum/read.php?406,576252,576805#msg-576805
As for what you said, I'm not sure I understand cause I'm not familiar with how to adjust the firmware.]]> StoneColdLoki Prusa i3 and variants Thu, 29 Oct 2015 00:00:32 -0400 https://reprap.org/forum/read.php?406,576252,576355#msg-576355 https://reprap.org/forum/read.php?406,576252,576355#msg-576355 bbg Prusa i3 and variants Wed, 28 Oct 2015 02:04:16 -0400 https://reprap.org/forum/read.php?406,576252,576252#msg-576252 https://reprap.org/forum/read.php?406,576252,576252#msg-576252
So while everything about the printer works fine, the E-Motor is not moving the filament through the nozzle. I manually step it 1mm at a time and nothing comes out. The filament goes through just fine, so there's no clogging or expanding or anything, and the motor is running fine, but there is no friction between them.

Can someone please help? i know I assembled it correctly (I upgraded to the MK8 Pro, so I dunno if that's any different.)]]> StoneColdLoki Prusa i3 and variants Tue, 27 Oct 2015 16:45:06 -0400