euroway reprap prusa i3 print head extruder motor wont grab/pull the filament through while trying to load or print all other stuff work fine(heating, xyz servos, connecting via computer) it seamed to toggle locked and free the same rate it would use to pull the filament through,pluging into the "X" axis port alows it to move as expected to. showing it may have some thing to do with the board or the chip, id try reinstalling the firmware but i dont wanna brick it anyone know what i should do next? im lost...i was so close too.... https://reprap.org/forum/read.php?406,615128,615128#msg-615128 Wed, 16 Sep 2026 20:56:54 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?406,615128,615128#msg-615128 https://reprap.org/forum/read.php?406,615128,615128#msg-615128
all other stuff work fine(heating, xyz servos, connecting via computer)

it seamed to toggle locked and free the same rate it would use to pull the filament through,pluging into the "X" axis port alows it to move as expected to. showing it may have some thing to do with the board or the chip, id try reinstalling the firmware but i dont wanna brick it

anyone know what i should do next? im lost...i was so close too....]]> adexin Prusa i3 and variants Sun, 24 Jan 2016 20:12:04 -0500