MKS Base V1.2 voltage adjustments Hello, I have a Tevo Tarantula with an MKS Base V1.2 board. I'm having problems with a under-extruding/clicking motor. Everything else seems to be working fine. It can print but the prints are very brittle and don't look good. I want to increase the current for the extruder motor, but I'm not clear how to do this. I tried searching around but can't find any info on this board. Any info would be greatly appreciated. Thank you. 69-1.jpg mod_embed_images_loadimage('e739d33b0355d7bd8223e77e3a2af779', '/forum/thumbcache/3c0/c5e/a2b/95c/58e/7e4/fac/cd1/faf/262/79_800x400.png', 'http://www.3dpmav.com/wp-content/uploads/2015/07/69-1.jpg', 'https://reprap.org/forum/addon.php?406,module=embed_images,check_scaling=1,url=http%3A%2F%2Fwww.3dpmav.com%2Fwp-content%2Fuploads%2F2015%2F07%2F69-1.jpg', '', 685436, 800, 400, 'Loading image ...', false); https://reprap.org/forum/read.php?406,685436,685436#msg-685436 Wed, 22 Jul 2026 00:38:02 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?406,685436,685454#msg-685454 Re: MKS Base V1.2 voltage adjustments https://reprap.org/forum/read.php?406,685436,685454#msg-685454
Move the E0 screw clockwise to my desired current. The + is the single tab and use any ground to measure.]]> shunfu Prusa i3 and variants Sat, 09 Jul 2016 17:46:12 -0400 https://reprap.org/forum/read.php?406,685436,685436#msg-685436 MKS Base V1.2 voltage adjustments https://reprap.org/forum/read.php?406,685436,685436#msg-685436
I have a Tevo Tarantula with an MKS Base V1.2 board. I'm having problems with a under-extruding/clicking motor. Everything else seems to be working fine. It can print but the prints are very brittle and don't look good.

I want to increase the current for the extruder motor, but I'm not clear how to do this. I tried searching around but can't find any info on this board. Any info would be greatly appreciated. Thank you.


]]> shunfu Prusa i3 and variants Sat, 09 Jul 2016 16:19:27 -0400